VWAP Standard Deviation Indicator
-
terminhandler
- Posts: 10
- Joined: Tue Jul 05, 2022 5:41 pm
- Has thanked: 1 time
- Been thanked: 1 time
Re: VWAP Standard Deviation Indicator
I then removed it, closed and restarted Bookmap. When I added the module, it threw the same exception.
Re: VWAP Standard Deviation Indicator
I believe wrong timestamp was configured for the Reset TimeStamp. For the hour it seems first 113 and then 900 was configured. I have prepared a version which ignores wrong timestamp, please find it attached. Give it at try.
-
terminhandler
- Posts: 10
- Joined: Tue Jul 05, 2022 5:41 pm
- Has thanked: 1 time
- Been thanked: 1 time
Re: VWAP Standard Deviation Indicator
Thank you very much! That seemed to fix the problem. I loaded it to BM in both trading and replay modes and it the issue hasn't surfaced again.
-
terminhandler
- Posts: 10
- Joined: Tue Jul 05, 2022 5:41 pm
- Has thanked: 1 time
- Been thanked: 1 time
Re: VWAP Standard Deviation Indicator
Hello again, Zoli. I'm using z0li-2.3.1.jar which you sent me a few months ago. It was working fine until today when it threw an exception when I entered the hh:mm:ss for a VWAP reset. Attached please see screenshots and the stack trace. Looking forward to you help again. Thank you and best regards,
- Attachments
-
- Capture2.JPG (83 KiB) Viewed 6034 times
-
- Capture.JPG (92.1 KiB) Viewed 6034 times
-
- stack trace.txt
- (2.29 KiB) Downloaded 370 times
Re: VWAP Standard Deviation Indicator
Your time stamp is not correct, you have entered:
"57`"
the extra` causes the trouble. Please remove it if you can. If it blocks the plugin to load, unfortunately you need to edit the Bookmap config file in the Config folder (bookmap_config_vXX.json). Open it in a text editor, look for the text "57`" and remove the extra character. Save the config and try to start Bookmap.
"57`"
the extra` causes the trouble. Please remove it if you can. If it blocks the plugin to load, unfortunately you need to edit the Bookmap config file in the Config folder (bookmap_config_vXX.json). Open it in a text editor, look for the text "57`" and remove the extra character. Save the config and try to start Bookmap.